Saw Blades Guide - Flipbook - Page 6
PLYWOOD / LAMINATE
CUTOFF
15°
0.012"
45°
10°-12°
TC GRIND
FOLLOWED BY FLAT RAKER
PLASTIC LAMINATE
SINGLE SIDED
PLYWOOD
LAMINATE (Single Sided)
EXCELLENT
MDF
EXCELLENT
CHIPBOARD
EXCELLENT
PLYWOOD
GOOD
CROSSCUT
FAIR
SLIDING TABLE
These blades are specifically designed for clean cuts in single-sided plywood laminates. The greater number of teeth, triple-chip grind and 10°12° hook angle provide an excellent balance between feed resistance and finish. This leaves a clean finish on the top side of the plywood or
plastic laminate materials. Some table saws require special scoring blades (KSB120-T14 see below) in conjunction with the KSB12-721-30 below to
accomplish clean cuts on double sided laminates.
Kerf
Dia.
10"
10"
12"
300mm
Teeth
60
80
72
72
MM
3.2
3.2
3.2
3.2
Inch
.126
.126
.126
.126
Plate
MM
Inch
2.2
.087
2.2
.087
2.2
.087
2.2
.087
Hook
Angle
12°
10°
12°
10°
Bore
5/8"
5/8"
1"
30mm
Pin-Hole
—
—
—
Tool No.
KSB10-601
KSB10-801
KSB12-721
KSB12-721-30
30mm bore accepts pin-hole arrangements of: 2/10/60, 2/7/42 & 2/9/46.
WARNING: Not recommended for cutting non-ferrous alloys and melamine.
ADJUSTABLE SCORING SETS
5°
15°
12°
ATB GRIND
MODERATE ANGLE
SCORING PARTICLE
BOARD & DOUBLE
SIDED MDF LAMINATE
DOUBLE-SIDED MELAMINE
EXCELLENT
PLASTIC LAMINATE
EXCELLENT
Used on panel saws and sliding table saws (ex. SCM, & Altendorf),
with separate scoring units for chip-free cuts on both sides of the
material. Adjustable scoring sets consist of two 12-tooth saw blades
with shims to adjust the kerf width (2.8mm to 3.6mm). These are used in
combination with our plywood/ laminate series Triple chip blade above.
SLIDING TABLE
PANEL SAW
Dia.
120mm
Teeth
12x2
Kerf
MM
Inch
2.8-3.6 .110-.144
Plate
MM
Inch
2.2(x2) .087(x2)
Hook
Angle
12°
Bore
22mm
Pin-Hole
—
Tool No.
KSB120-T14
WARNING: Not recommended for cutting non-ferrous alloys.
SAW BLADES
6
Call Toll Free 800-645-5555
