2025 KLINGSPOR BIG Catalog - Catalog - Page 136
DOUBLE-SIDED
MELAMINE
30°-40°
20°
5° NEG
MELAMINE SINGLE &
DOUBLE SIDED
H-ATB GRIND
HIGH OR ACUTE ANGLE ALTERNATIVE
TOP BEVEL
MELAMINE
EXCELLENT
LAMINATE
EXCELLENT
PLYWOOD
GOOD
TABLE SAW
CHIPBOARD
GOOD
SLIDING TABLE
These blade is designed for smooth crosscuts in a variety of materials from hardwoods, softwoods and sheet stock including chipboard. Not
intended for sliding miter or radial arm saw applications.
Dia.
10"
12"
Teeth
80
96
MM
3.2
3.2
Kerf
Inch
.126
.126
MM
2.2
2.5
Plate
Inch
.087
.100
Hook
Angle
-5°
-5°
Bore
5/8"
1"
Pin-Hole
—
—
Tool No.
KSB10-803
KSB12-963
Price
$180.36
$216.45
WARNING: Not recommended for cutting non-ferrous alloys.
TERMINOLOGY
1.
Blow out: A condition in which the saw blade blows out the
grain of a workpiece.
2. Chipping: A condition that occurs when the saw blade lifts
and tears the wood fibers as it exits the material.
9. Non-Ferrous: Any metal not containing iron.
3. Crosscutting: Cutting wood against the grain.
4. Cut off: Cutting a piece to length (Same as Crosscut)
5. Hook Angles: The amount of forward or backward lean
each tooth has. The angle is measured by the intersection of
two imaginary lines. The first line is drawn flush with the face of
the tooth, the second line is drawn vertically through the center
of the arbor hole.
6. Kerf: The width of the cut made when the blade passed
through the material, determined by the width of the tooth.
7.
8. Negative Hook Angle: The negative face of the tooth is
much less likely to cause chipping in the surface of the material
because it is oriented in a counter-rotation direction. This will
prevent self feeding.
10. Positive Hook Angle: The higher the hook angle, the
more aggressive the blade will cut the material. This is great for
getting through a lot of material fast.
11. Ripping: Cutting wood in the same direction as the grain.
12. Run out: The amount of wobble in a saw blade, also known
as warp.
13. Thick Wall: Cutting a non ferrous metal over 1/4" thick
14. Thin Wall: Cutting a non ferrous metal under 1/4" thick
Miter: A finish cut made at an angle.
Visit us online: www.klingspor.com
135
SAW BLADES
Saw Blades
SAW BLADES
